This is final project report.
Part I:
Design a circuit that has a total of 6 voltage measurement points. The voltage measurements should be in the following order 15V, 12.5V, 10V, 5V, 3V, 1V. Limitations: you must not have a source voltage equal to 15V and your voltage measurements should be within 0.1VDC of the specified point.
Part II:
Design a non-inverting operational amplifier circuit that accepts 5VDC and has an output of 12.5VDC. Limitations: The output voltage should be within 0.1VDC of the specified output.
Part III:
Design an inverting operational amplifier circuit that accepts 2VDC and has an output of -6VDC. Limitations: The output voltage should be within 0.1VDC of the specified output.
Part IV:
Design an inverting operational amplifier circuit that accepts 6Vpk-pk and has an output of 14Vpk-pk. Limitations: The output voltage should be within 0.1Vpk-pk of the specified output.
Please read the report guidelines that is attached, follow it word by word. If you want to know what to write in each section see the guidelines that is attached If it is not followed i will request a revise paper. Dont do data section i will do it myself
Most important:
Only put these headers
objective
(2-3 sentences)
Introduction:
(5-8 Sentences),
Equipment and Software:
Data : dont do it i will do it myself
Analysis: (2 paragraphs 6 sentences each)
No equations no calculations just if you want to talk anything you can write for example as shown in table 1. Also please follow the guidelines in report format.
Conclusion:
(6-8 sentences)
As required in guidelines
If there anything missing please let me know
